INSTALLATION INSTRUCTIONS
For Flex II
300 Watt Magnetic
Transformer - Wall
Fixture
Track
Fixture
Flex II Track
Metal Connector
Flex II Track
Fixtures
Metal Connector
Pin holes
Pin holes
_________________
tel.800-670-8137 www. lightwavesconcept .com
_________________
tel.800-670-8137 www. lightwavesconcept .com
SAVE THESE INSTRUCTIONS
AND REFER TO THEM WHEN ADDITIONS
TO OR CHANGES IN THE TRACK CONFIGURATION ARE MADE.
Light Waves
LED Waves
Light Waves
Lighting SuperStore
Follow these instructions during first-time Flex II Track System installation, or when replacing bulbs:
A] Make sure the power is off.
B] Allow the fixture and bulb enough time to cool down.
C] Remove installed fixtures from the track.
D] Insert the bulb pins into the fixture’s pin holes [Fig. 1] until the bulb is held tightly and securely in place, making sure the bulb is aligned properly. [Fig. 2] Do
not twist the bulb when inserting it into the fixture; this may bend the pins and lead to fixture failure.
E) Mount the fixture on the track according to the instructions in the appropriate section of this manual.
Bulbs
Fixtures
1] When mounting the fixture make sure the metal connectors align properly with the power
track. The metal connectors on the fixture should touch the metal connectors on the flex
track. [Fig. A]
2] Remove the cap from the fixture and place fixture on the track.
3] Replace the cap and tighten. (Fig. B)
Fig. 1
Fig. 2
Fig. A
Fig. B
Use only the MR16type bulbs specified for use with your fixtures.
Use IRC bulbs for commercial installations.
1
2
3
4
6
6
5
