Specifications
Product code: L/H EBIKEFRR
This bike light set utilises the latest technology
in portable lighting, allowing extremely bright
LED lights to be encased in lightweight and
compact units.
The powerful 150 lumen front light features
three light settings:
• High 100% , • Low 50%, • Strobe.
The rear light has six settings:
• Solid High, • Solid Medium, • Solid Low,
• Flashing High, • Flashing Low, • Strobe
Battery Recharging
The light must be fully charged for a
minimum of 5 hours before being used for
the first time, this will ensure that the battery
gives its best performance now and on future
re-charging cycles.
The charging cable is for recharging the
battery only. It cannot be used to directly
power the light.
Failure to recharge the light every 3 months
may permanently damage or reduce the
performance of the light. The battery charge
does not have to be fully depleted before
recharging.
Using the Charging Lead
Plug the USB charger lead into the micro
USB charging socket on the back of the light.
Plug the other end of the lead into any USB
charging outlet.
While on charge the charging indicator lamp
will glow red. It will turn green when the
battery is fully charged (approximately
5 hours).
Please note the following
1) For best performance Li-polymer batteries
should not be stored for prolonged periods
without being charged at regular intervals.
2) It is recommended to keep the battery in a
state-of-charge of 40-50 percent when
placing in storage. If in doubt, keep the
light in a higher charged state in a cool
place.
3) Self-discharge rate is approximately
10% per month.
148 x 210mm
2.5 / 4.5 hours
150 Lumens
XPG 3W LED
IP54
Water resistant
1M
Impact resistant
Battery
3.7V 800mAh
Li-Polymer
3.7V 330mAh
Li-Polymer
Charge time
approx 5 hours
Brightness
Light source
Run time
52g
Weight
62 x 30 x 30
Dimensions
(mm)
Rubber attachment straps
USB charging cable
10 hours
100 Lumens
COB LED
IP54
1M
approx 5 hours
High / Low /
Strobe
Modes
Solid / Flash /
Strobe
37g
41 x 41 x 38
Supplied with
Front
Rear
