MR Protocol Commands
248083227-1 Rev 8
A-3
Universal Device Select
The counter will respond to all commands given after the
U
command,
regardless of its programmed Location Address.
If more than one counter is connected to the Serial Port, the use of the
U
command will cause communication problems because all counters
will respond at the same time.
The
U
command is turned off by sending any Device Select address as
described above.
Command:
U
{Unit will respond to all commands}
(Press/Hold) ALT 0135
{U disabled}
Configuration
Commands
The general forms of a Configuration Command are displayed in Table
A-2 and Table A-3.
AAd[CRLF]
where:
•
AA
is the command field and is always capitalized
•
d
represents an argument, which may be numeric or a string,
depending on the command. The argument immediately follows the
command with no space between them.
•
[CRLF]
means carriage return and line feed. When it appears at
the end of a command,
Table A-2 Command Set for Displaying Current Configuration
COMMAND
RESPONSE
DESCRIPTION
WA[ENTER]
WA#[CRLF]
Displays current Alarm Limit
where # is value from 0-999999
WL[ENTER]
WL#[CRLF]
Displays software configured
Location Address used when DIP
switch 7 is ON and DIP switch 8 is
OFF. # is value from 0-63.
Summary of Contents for RLPC 0.1m
