Installation
There are specific regulations like BGV C1 (old VBG 70) or OStrV und BGV B2 or country related
regulations which need to attend during the installation. The installation has to be handled by
skilled persons only!
Suspension device has to be built and calculated in order to handle up to 10 times its specific load
limit over a time of one hour without permanent or harmful deformation.
Installation has to be done with a separate, independent suspension device like a safety chain. A
second suspension device has to be built in order to assure that in case of error no part of an
installation can fall off.
Tresspassing the danger zone below the installation during the assembling is prohibited.
Installer has to take care of all safety and machinery installations are approved by authorized
persons before first operation or after changes before restarting.
Installer has to take care of all safety and machinery installations are approved by skilled persons
at least once a year.
Installer has to take care of all safety and machinery installations are approved by authorized
persons at least every four years during the acceptance inspection.
Laser device should ideally installed outside peoples lounge area
.
ATTENTION!
Installation overhead needs a high level of experience. This includes (but is not just limited to) calculation
and definition of load capacity, used installation material and regular safety inspections of used material
and the fixture itself. Never try to do the installation by yourself if you are not qualified, instead you have
to instruct a skilled installer. Inappropriate installations can cause injuries and/or damage of property.
Laser device has to be installed outside areas where people can touch it.
Professional truss system or similar licensed suspension systems have to be used if the Laser
device is used in suspension from ceiling or other constructions. Laser devices can never be
installed freely suspended!
ATTENTION!
Laser devices can cause injuries when fall off. If you are not trained in questions of safety for the different
kinds of installation do NOT install the Laser device!
Assure that the mounting surface can hold at least ten times the point load of the Laserdevice
before installing the fixture.
ATTENTION!
Assure the specified safety distances to flammable material.
Attach the Laser device with its yoke and the use of a suitable hook/clamp to your truss system.
According to your installation also similar but approved suspension devices are possible. The beam
output has a diameter of about 12 mm.
When installing the Laser device overhead make sure to safe the fixture by a safety chain which is
specified at least with a load limit of 12 times of the Laser devices weight. Only safety chain with
approved connective can be used. Attach the safety chain to its designated opening and attach it to
the truss system or a similar and safe attachment point. Assure to close the fasteners as specified.
To adjust the angle of the fixture open the locking screw, set the fixure in its position and close it by
hand.
