INSTRUCTION SHEET NO.
© 2000
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
LIGHTOLIER a GENLYTE THOMAS company
631 Airport Road,Fall River MA 02720
INSTRUCTION FOR BALLAST REPLACEMENT
4.
ATTACH MOUNTING RING (FIG. F & G)
Push MOUNTING RING into opening until FLANGE sits against
ceiling. Slide MOUNTING STRIOPS down to trap ceiling thickness
and then bend up to secure.
MOUNTING CLIP
MOUNTING RING
FLANGE
FIG. F
FIG. G
IS:1102TH1R
B0600 Page 2 of 2
BALLAST REPLACEMENT
1. TURN POWER
OFF
2. Remove REFLECTOR TRIM from ceiling (see REFLECTOR TRIM
instructions).
3. Remove BALLAST ASSEMBLY by lifting SPRING on top of J-BOX
and pull BALLAST outward. (Fig. K)
4. Disconnect all wiring.
5. Remove BALLAST ASSEMBLY from J-BOX by pulling SPRING
upward.
6. Remove BALLAST ASSEMBLY through ceiling opening.
7. Disassemble (2) locknuts which held BALLAST to J-BOX COVER.
(Notice orientation of two MOUNTING FINGERS on bottom and
one MOUNTING TAB on top of COVER. They are on the opposite
(inside) surface of the door from which BALLAST is mounted.)
8. Replace old BALLAST with new BALLAST and lock with locknuts.
9. Reassemble new BALLAST ASSEMBLY to J-BOX by replacing
TABS into SLOTS on frame, snap onto SPRING.
10. Rewire Fixture. (SEE WIRING DIAGRAM ON BALLAST LABEL.)
5.
PULL-THRU (FIG. H)
6.
PUSH-UP (FIG. I)
7.
SNAP-IN (FIG. J)
SEE SEPRATE REFLECTOR TRIM
INSTRUCTION SHEET
FIG. H
FIG. I
FIG. J
FIG. K
SPRING
J-BOX
J-BOX
BRACKET
BALLAST
SLOTS
J-BOX
COVER
TABS (2)
IN J-BOX
COVER
BALLAST
ASSEMBLY
