4
IG_Lucid _nova_pro_EN_09.03.2018_V2.0 - Similar to illustrations, technical data are subject to change
Installation - general safety instructions
CAUTION - DANGER OF ELECTROCUTION
Only appropriate technical personnel may work on electrical systems. There is a risk of fatal electrocution. Before
working on electrical systems and switching units, they should be removed from the power supply and secured
against accidental re-connection. Before touching conductive components and cables, use appropriate equipment
to confirm they are actually isolated from the power supply.
•
First read the operating instructions through completely, as they contain important information for correct
fitting and operation.
•
Any damage caused by non-compliance with these operating instructions invalidates the warranty/guarantee!
We do not accept any liability for direct or consequential damages!
•
We do not accept any liability for personal or property damage caused by improper use or non-compliance
with the safety instructions! In these cases, the warranty/guarantee is invalidated!
•
The product may not be opened (please also read the instructions in the chapter MAINTENANCE).
•
The light source in these luminaires is not replaceable. When the light source has reached the end of its life,
the whole light must be replaced
•
Do not install the product on a damp or conductive surface.
•
To avoid any hazard, a damaged outer flexible lead on this light may only be replaced by the manufacturer,
their representative or a comparable qualified person.
•
Only install the product in switched-off mode.
•
Only install the product in intended electrical systems and voltage ranges. Check and compare the informa-
tion on this on the product’s type plate.
•
If a fault occurs, disconnect the product from the mains power supply and any other connected devices. Then
ensure neither can be switched on again accidentally.
•
If you cannot guarantee that the product can be operated without any danger, disconnect the product imme-
diately from the mains power supply and any other connected devices. Once more, ensure neither can be
switched on again accidentally. It is not possible to guarantee that the product can be operated without any
danger when, for example, the housing or power cable is damaged, or if any foreign objects have penetrated
it.
•
Use suitable, approved power cables and cable connectors / clips of an adequate size. Make sure the cables
sit firmly in the connectors. Any loose or exposed cables represent an extremely high risk of electric shock
and fire.
•
When working under roofs, on masts or any other high fitting sites, ensure you are on a solid base by us-
ing approved, certified ladders, or risers, as well as fall protection for personnel, tools and the product to be
installed. Cordon off the area under the installation area adequately.
•
Caution: Please consult specialists before using the luminaires in high ambient temperatures or chemically
polluted environments.
