Section 2
Initial Setup
Setting the Time / Date
If the iTimer is connected to the internet the clock will auto-set. If not, it can be set
manually as follows;
Display the config menu by pressing the
“
OK
” key once. The display will change to
show the options. Press “
OK"
key again to
select the clock setup page..
Note the flashing cursor by the hour value.
Press the “
OK
” key to select it. The hour value
will start to flash to indicate it can be changed.
Use the UP and DOWN keys to set the value
then press the “
OK
” key to return to the cursor.
Step through each setting using Up/Down keys to navigate using the “
” key until
the time and date are set. When complete, navigate to the BACK position and press
“
OK
” key to exit the set-up and return to the main display.
SETTINGS…
Time / Date
Timers
PIR Timer
All off Timer
Dusk / Dawn Timer
SET TIME & DATE
00:15
13 Nov 2019
BACK