www.lightware.eu
Firmware version: 1.2.0b5
For technical support contact support@lightware.eu
Document revision: 2.0
MODEX Extender Family
Quick Start Guide
Set dynamic IP address
Navigate to the Settings/Network settings/DHCP submenu
and press the enter button. Select the Enabled setting and
press the enter button. Press the Escape button twice and
apply the settings by the enter button.
Using the built-in website
The extender can be controlled via a simple web browser. Make sure that the device is
connected to the same network as the control PC. Type the IP address of the MODEX into the
address line of the browser.
Info: More information about the built-in web can be found in the User’s manual of the MODEX.
Restart the device
Navigate to the Settings/System/Reset submenu and press
the enter button. To restart the device, confirm your selection
by pressing the enter button again.
The other way is to press the hidden Reset button on the front panel by a thin tool (e.g.
paperclip). The device is restarted immediately.
Restore factory default settings
Navigate to the Settings/System/Fact.defaults submenu and
press the enter button. To restart the device, confirm your
selection by pressing the enter button again.
Firmware upgrade
MODEX can be upgraded by connecting a Windows PC via LAN and using Lightware Device
Updater (LDU). The application can be downloaded from
www.lightware.eu
. In order to get the
firmware pack with the necessary components (*.lfp file) for your specific product, please
contact
support@lightware.eu
.
The upgrading steps:
1.
Get the firmware pack and the Lightware Device Updater (LDU) application.
2.
Install the LDU application.
3.
Connect the computer to the MODEX device(s).
4.
Start the LDU and follow the instructions shown on the screen.
Info: For more information about the process please refer to the User’s manual of the MODEX.
Factory default settings
Parameter
Setting/Value
Network settings
IP address (transmitter)
192.168.0.101
IP address (receiver)
192.168.0.102
Subnet mask
255.255.255.0
Static gateway
192.168.0.1
Port number
6107
DHCP
disabled
HTTP port
80
WEB socket
81
HDMI input port
Input port
HDMI
HDMI output port
HDMI mode
Auto
Color space
Auto
HDCP mode
Auto
Color range
Auto
Serial port (RS-232)
RS-232 Baud rate [baud]
9600
RS-232 data bits
8
Stop bits
1
Parity
None
Infrared port
IR input carrier frequency [Hz]
38000
IR output carrier frequency [Hz]
38000
Analog audio ports
Application mode
(0) Analog
Emb. & Ret. Aux
Analog in Gain [dB] (only on input)
0
Analog out Volume [dB]
0
Analog out Balance
50% (centered)
Invert phase
disabled
DC filter
disabled
EDID settings
DVI port
D1 (dynamic)
HDMI port
D1 (dynamic)
Info: The User’s manual of MODEX is available on
http://www.lightware.eu/modex
.
¹System
¾Reset º
¹System
¿Fact. defaultº
¹Network SettinÞ
¿DHCP º
