NOTE: Linking mode
lasts for 12 seconds; if no signal is received from a
controller during this time then the socket will automatically exit linking
mode without linking the device.
If, when expecting a quick flashing LED to confirm pairing, a slow flash is
received instead, then the relay memory is FULL and no further remotes
may be linked with it unless one of the existing remotes is unpaired first (see
below).
1.
On the relay, press and hold down the
linking button until the LED flashes
alternately, and then release it. That relay
is now in
linking mode
.
2.
Using a LightwaveRF controller,
Smartphone or Web App, press the button
intended to be unlinked; the LED light on
the relay will flash to confirm that the
App/controller is now unlinked.
Unlinking controllers and clearing the Inline Relay memory
Removing a single device:
Device setup
Linking
button
