To directly control a LightwaveRF TRV, Thermostat or
Electric Switch using a Magnetic Trigger, you will need to
‘link’ them. The trigger can be linked to these devices
using the following method:
1.
Press and release the ‘Linking’ button on the Magnetic
Trigger (the LED will flash).
2.
Press and release the Linking button on the TRV,
Electric Switch or Thermostat that you wish to link to.
The ‘on’ LED should flash to indicate a successful link.
Note:
linking mode lasts for 12 seconds; if no linking
command is received within this time, then linking mode
will time out and the process will have to be re-initiated.
To completely clear the memory of the Switch and unlink
any linked devices, press and release the Linking button to
enter linking mode (the LEDs will flash). Then, hold the
Linking button until the LEDs flash rapidly. Finally, press and
release the Linking button once more. The LED will flash
more slowly to confirm that the memory has been cleared.
Linking the trigger to a TRV, Electric Switch or Thermostat
Device setup