Troubleshooting
Troubleshooting
24
25
II
The spotlight switches on at full luminosity
once the motion sensor is activated.
Afterwards, the spotlight decreases in
luminosity (night light function) and continues
to illuminate until the motion sensor is
reactivated.
Troubleshooting
Fault
Possible cause
Solution
The product
does not
switch on
despite
movement
in the sensor
area.
The rechargeable
batteries are
discharged.
Remove any dust, dirt
or snow from the solar
panel
15
and re-
position it if necessary.
The rechargeable
batteries are faulty.
Contact the After Sales
Support.
The lighting in the
immediate vicinity
is too bright.
Re-configure the
LUX controller
2
or
find a more suitable
installation location.
The sensor area
is not correctly
configured.
To correctly set up the
sensor area, turn the
motion sensor housing
10
.
The product is
defective.
Have the product
repaired by a
professional.
Fault
Possible cause
Solution
The LEDs
shine less
brightly.
The rechargeable
batteries could not
charge sufficiently
because the
solar panel is
not receiving
enough direct
solar radiation or
daylight.
Select another
installation location
for the solar panel
15
(see chapter “Selecting
the installation
location”).
Note that there is
generally less sunlight
in the winter months.
Wait for a sunny day if
necessary.
The rechargeable
batteries could not
charge sufficiently
because the solar
panel is dirty.
Remove any dust, dirt
or snow from the solar
panel and re-position
it if necessary.
The sensor
area is too
small.
Sunlight can cause
faults when setting
the sensitivity.
Test the settings
again in the evening
and re-configure the
sensitivity if necessary.
