86
Preventative Maintenance Viking XL
www.liko.com
10.0
Instructions regarding the check points
Remove link arm cover, bolt and nut.
Clean, lubricate and reassemble pivot bolt, bearing sleeves and hardware.
Inspect the legs at the linkage. If the linkage are in poor condition, replace them
with Restoration set motor attachment.
(For Spare Part No, see the Spare Parts List)
Reconnect actuator to link arm. Apply plastic hardware covers.
x2
Restoration set motor attachment
6 Base motor linkage
7 Lift arm
x2
x6
x3
x6
x2
Overhead beam Restoration set
(For Spare Part No, see the
Service Manual.)
Remove hardware covers.
Remove and lubricate lift arm bolt.
Visually inspect lift arm, plastic covers
for wear, cracks or deformation.
Reassemble in reverse order.
Raise the arm and then release,
so that it falls to the lowest position.
If the arm does not fall to the lowest position, the screw is too tight.
Remove and lubricate actuator hardware. Visually inspect actuator
plastic bushings for wear. Replace if worn. Reassemble in reverse
order.
Viking XL Viking L Viking M
Overhead beam Rest. set needs to be replaced after: 1020 Ah
910 Ah
700 Ah
or
Replace according to years in use:
10
10
10
Summary of Contents for Viking XL 2040003
