10
INSTALLING THE RECEIVER
Mounting the Receiver.
When using the saw for vertical cuts, always mount the receiver on the back of
the loader bucket near the top.
When using the receiver for horizontal cuts, mount the receiver inside the bucket.
Using the provided bolts, drill
½
” holes and securely tighten bolts. Receiver can also be welded in place.
ASSEMBLING THE SAW
(continued)
CAUTION: Circular saw blade teeth are sharp.
Use gloves and extreme caution when handling blade.
Mount saw blade with printed side facing motor shown.
— not showing on guard side of saw.
This insures that the blade is mounted in the correct position for cutting. Remount black
fl ange washer and castle nut. Tighten castle nut very fi rmly and reinsert cotter pin in
available hole. As you tighten castle nut you can place a screw driver between teeth of
blade to keep blade from spinning. Reattach orange blade guard with 4 bolts.
Location of the Damper.
For proper operation, the Damper
MUST be located with the large end facing the motor and
using the holes shown.
Review the image carefully and locate the Damper correctly.
(NOTE: Hydraulic hoses in this image have been removed for clarity)
Flange washer has marking on inside edge
Be sure this edge faces blade during installation.
Mounting location of Receiver for
VERTICAL CUTS
Mounting location of Receiver for
HORIZONTAL CUTS
