68
MIXING CONCRETE AND MORTAR
When mixing concrete and mortar, ensure mixer drum is secure in correct mixer position. Only the
correct mixer position can produce optimum results and ensure problem-free operation.
Filling and discharging can only be performed when motor is running. Note drum rotation direction.
SEE INDICATOR ON DRUM!
Hand wheel and position disk to tip drum and lock fast at required position.
DISCHARGING DRUM. TIP DRUM TO DISCHARGE POSITION (3), START ROTATION BY PRESSING
SWITCH. HOLD HAND WHEEL TIGHTLY WHEN TIPPING DRUM.
1. Mortar
2. Concrete
3. Discharging and cleaning
4. Transport
Release hand wheel for tipping drum. Position drum in one of mixer positions (concrete or mortar)
by turning hand wheel. POSITION DISK SETTINGS.
Mixing concrete/mortar
1. Adding water and base materials (sand, gravel etc...)
2. Add binding agents.
3. Repeat steps 1 and 2, until required mix ratio is attained.
4. Mix material until mix is uniform. Add water.
Refer to a professional for exact amounts of base material, binding agent and water to ensure
a good mix.
HOLD HAND WHEEL TIGHTLY,
WHEN DISCHARGING DRUM
Filling and discharging of mixer drum can only be performed when motor is running and drum
rotating.
Check that it is stable and level.
Release lock mechanism on hand wheel by pulling it towards you. Tip mixer drum slowly, set drum
in discharge position using hand wheel. Repeat procedure.
ENGLISH
INSTRUCTION MANUAL
Summary of Contents for 80053
Page 87: ...87 ILLUSTRATION ...
Page 88: ...88 PART LIST ...
