IS792 ECN 4879
Page 26 of 37
- Use powder or foam extinguishers.
Cleaning the interior and exterior of the appliance
The appliance is designed for the products storage so it is important to keep it clean. The
equipment is thoroughly cleaned at the factory before being shipped. We recommend,
however, to clean the interior cabinet before the first start up of the appliance.
Before
attempt any cleaning operation make sure the power cord is disconnected.
-Cleaning product: use soft clean cloth wet with water and neutral detergent only.
Do not
use solvent or bleach.
-Rinsing: use a soft cloth or sponge soaked with fresh clean water.
Do not use water jet.
-Wipe with a soft, clean towel to prevent water spotting
.
Stainless door panels, handles and frames can discolor when exposed to chlorine gas,
pool chemicals, saltwater or cleaners with bleach.
Keep your stainless unit looking new by cleaning with a good quality all-in-one stainless
steel cleaner and polish monthly. Some installation may require cleaning weekly.
Do not clean with steel wool pads.
Do not use cleaners not specifically intended for stainless steel on stainless steel
surfaces
.
Condenser cleaning
The condenser is a heat exchanger. If it is dirty or clogged the air cannot circulate freely
through the same, it cannot discharge heat properly so reducing proportionally the
performance and the efficiency of the refrigeration system.
FOR THOSE REASONS IT IS IMPORTANT TO KEEP CLEAN THE CONDENSER COIL,
TYPICALLY MONTHLY.
Always switch off the unit and disconnect power cord before cleaning, it is
dangerous to do it with power ON: fan may start suddenly at any time.
Use a convenient ladder to reach the condenser. Use an air jet or vacuum with a soft dry
brush if necessary and remove any dust or fluff from the heat exchanger fins.
After cleaning, start the equipment.
During the cleaning operation wear gloves and safety glasses to protect yourself from
any injury
MESSAGES AND INDICATIONS
6.1 MESSAGES
L1
“On”/”Stand-by” LED
-if permantly ON, a chilling or freezing
operation is ongoing
-if flashing, a storage operation is
ongoing
L2
Needle probe LED
-if permanently ON, the temperature
measured by the needle probe is
being displayed
-if flashing, then the result of the test to