IS792 ECN 4879
Page 6 of 37
convey condensate to exterior, no rough surfaces, fixed guards protecting moving or
potentially dangerous parts.
1.4 GENERAL SAFETY REGULATIONS
Read this manual carefully and follow the instructions contained herein.
The user assumes full responsibility in case of operations carried out without
observing the instructions in the manual.
Do not use this product with flammable gases or flammable solvents.
Do not store flammable gases, flammable liquids or flammable solids in these
units.
Primary general safety regulations:
Do not touch the unit with wet hands and/or feet. Do not use the equipment with bare
feet;
Do not insert screwdrivers or other pointed objects between guards or moving parts
of the equipment;
Do not pull the power cord to disconnect the equipment from the electrical mains
Make sure that the equipment is not used by unsuitably qualified persons;
Before performing any cleaning or maintenance on the equipment disconnect it
from the electrical mains by switching off the main switch and extracting the plug;
Never
use any metallic scouring pads, brushes, abrasive cleaners or strong
alkaline solution on any surface.
The relocation of the unit must be performed by qualified personnel. Do not shift
the refrigerator from side to side as this may create leakage point across the
cooling unit piping.
In case of faults or malfunctions, switch off the equipment and do not attempt to
repair it by yourself as doing so may void the warranty. All service and repair
operations must be performed exclusively by a manufacture’s authorized engineer.
(Authorized service technician, trained service personnel, authorized service
personnel)
This application, like any other appliance, must have access to fresh air/oxygen;
Keep clear of obstruction all ventilation openings in the appliance enclosure or in the
structure for building-in
.
Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
WARNIN
G: Do not damage the refrigerant circuit.
Do not use FLAME to check for gas leak.
Do not under any circumstances
try to modify or repair valves, regulator,
connectors, controls or any other appliance. Doing so creates the risk of a gas leak.
1.5 CUSTO
MER’S RESPONSIBILITIES
The customer is required to:
Execute the electrical connection of the equipment Prepare the place of installation;