IS 599 ECN 3856
Page 7 of 9
SERVICING, MAINTENANCE AND COMPONENT
REPLACEMENT
Your Lincat product has a manufacturer’s warranty. This requires you to maintain
and care for your product and follow maintenance instructions. If you fail to maintain
your unit or damage components Lincat may charge you for a warranty repair.
Please check the website for terms and conditions.
All servicing, maintenance and component replacement on this appliance should be
carried out by one of our recommended service engineers.
Component replacement
The following components are all accessed by turning the appliance either on to the
side or top and then removing the control panel and base panel section.
Neon
Remove the cables from the neon and unscrew the retaining collar.
Withdraw the neon.
Fit the new neon and reverse the procedure to reassemble.
Element
Disconnect the cables from the element terminals and withdraw the control
thermostat and safety thermostat bulbs.
Undo the nuts holding the element and support ring to the tank.
Remove the element and seal from the inside of the tank.
Ensure the mating face of the tank is clean. Fit new element and seal assembly.
Reverse the procedure to reassemble.
Control thermostat
Remove the control knob
– do not loose the clip.
Slide the thermostat bulb from the element mounting.
Remove cables from the thermostat, unscrew thermostat from the facia panel.
Fit new thermostat and reverse procedure to reassemble.
