IS 607 ECN 4345
Page 9 of 12
Remove the bracket and remove the stat.
Remove the control knob and the screws holding the thermostat to the clam facia.
Fit new thermostat by reversal of the above procedure. Do not damage the
capillary.
Ensure the stat bracket in not in direct contact with any part of the element sheath.
Element Replacement
On the griddle plate:
Remove the screws beneath the facia panel, and remove the facia panel by rotating
the bottom forward.
Disconnect the element cables from the terminal block, noting their location.
Remove the stat bracket containing the stat bulb from the element cartridge.
The elements are contained in a cartridge unscrew the M6 nuts of the cartridge
strap, this will allow the cartridge to drop down at the front.
Remove the element cartridge and fit the replacement, locating carefully reposition
the cartridge beneath the griddle plate and tighten up the cartridge strap.
Fit stat bracket and facia by reversal of the above procedure.
On the clam plate:
Remove the top panel of the clam arm and disconnect the element cables from the
terminal block, noting their location.
Remove the cover plate and release the rubber grommet from inside the head to
allow access to the stat bracket fixing screws and remove.
Remove the stat from the bracket.
Release the compression of the springs by backing off the adjustment nuts, firstly
making a note of the adjustment nuts position and lifting action ready for
reassembly.
Undo the fixing screws (x8) that attach the cover from the top plate and inner frame.
Lift the arm body allowing access to the element cartridge and replace with new.
Reverse the sequence to fit new element cartridge and reassemble.
Note: Adjust the compression springs during reassembly to give the correct lifting
action.
