IS 688 ECN 4178
Page 12 of 13
SERVICING, MAINTENANCE AND
COMPONENT REPLACEMENT
Removing the air filter
Removing and cleaning the air filter will ensure an adequate supply of cool air and
restore performance. Disconnect from the power supply and allow the appliance to
cool. The filters are located on the base of the unit.
At the back of the unit on the hob top is a metal cover. Lift this vertically to remove
the housing, filter holder and filter. Remove the filter from housing. This filter can be
cleaned in a dishwasher.
Do not operate the appliance without a filter being fitted, otherwise dirt and grease
could be drawn into the electronics, impairing safe operation and invalidating the
warranty.
All other servicing, maintenance and component replacement on this appliance
should be carried out by one of our recommended service engineers.
Please refer to the Service Help Desk number on the final page of this manual.
Fault codes are listed in the Operating section above.
Part Number
Description
FI36
Filter pad
KN506
Hob control knob
KN523
Oven control knob
CA143
Front lockable swivel castor
CA145
Rear swivel castor
SE25
Oven door seal (3metres required)
FAULT FINDING
SPARE PARTS LIST