IS 283 ECN 3607
Page 4 of 6
If replacing the plug connect the terminals as follows:
Green and Yellow wire Earth E
Blue wire Neutral N
Brown wire Live L
Supply cords shall be oil resistant, sheathed flexible cable not lighter than ordinary
polychloroprene or equivalent elastomer sheathed cord (code 60245 IEC 57)
Install this appliance on a level surface.
OPERATING INSTRUCTIONS
Only qualified or trained personnel should use this appliance.
Ensure the base plates lay flat within the base, and the shelves are secure.
Connect the appliance to the electricity supply and switch on the light using the
green switch.
Adjusting the shelf positions
Disconnect from the electricity supply. Slide the doors to the middle and lift up and
out of the runners to remove. Lift and rotate the shelves to remove. Use the Allen
key provided to adjust the shelf supports
– at the front remove the two screws and
replace in the appropriate holes, at the rear the screws are located behind the cable
panel. Carefully remove the cable panel first and then reposition the rear shelf
supports. Replace the cable panel ensuring the cable is not trapped.
CLEANING
Do not use a water jet or steam cleaner, and do not immerse this appliance.
Remove the rear doors, shelves and base plates. Brush the crumbs into the tray.
Shelves, shelf supports and base trays may be washed in a dishwasher, clean all
other panels with warm water and mild detergent, do not use abrasive materials.
Dry with a soft cloth.
