12
J5/J10 Component Replacement.
Ignitor Electrode and Pilot Jet
1.
Undo pilot gas feed pipe, the pilot jet will come away when the pipe is removed.
2.
Undo two screws attaching pilot mounting bracket to front of burner chassis and drop pilot assembly
clear of chassis.
3.
Disconnect igniter lead from bottom of igniter.
4.
Remove igniter electrode, held to bracket by a single screw.
5.
Reversal of above for reassembly. Ensure pilot jet is refitted when fitting pilot pipe.
Thermocouple.
(This operation is easier if the pilot assembly is removed, see above).
1.
Undo the brass nut on top of the bracket which secures the thermocouple to the pilot bracket and pull
down.
2.
Undo the nut holding the thermocouple into the rear of the valve.
3.
Disconnect the wires from the interrupter terminal block
4.
Replace the thermocouple
5.
Reversal of the above for re assembly.
Thermopile.
1.
Disconnect the thermopile lead at the control valve.
2.
Loosen the thermopile retaining nut
located underneath the pilot assembly.
3.
Withdraw the thermopile from the pilot bracket.
4.
Reversal of above for reassembly.
Control Thermostat.
1.
Drain fryer
2.
Remove the Thermostat control knob and the control panel facia.
3.
Disconnect the wires from the thermostat and remove the screws holding the thermostat to the facia.
4.
Remove the small gland assembly nut where the capillary enters the tank.
5.
Free the thermostat phial from thermostat clip inside tank.
6.
Reversal of the above for re assembly.
