13
Gas Control Valve.
1.
Disconnect the thermocouple, thermopile and thermostat connections.
2.
Remove the piezo igniter button assembly, held by a single screw on front of valve.
3.
Disconnect the pilot pipe, gas supply pipework and the burner pipework
4.
See previous notes for thermostat replacement and thermocouple replacement.
5.
Remove four screws securing the valve to chassis.
6.
Remove brass fittings from old valve and fit these to the replacement valve. N.B. Replacement valves are
not supplied with the brass fittings.
7.
Reversal of the above for re assembly.
8.
For propane units remove the governor cap, unscrew the adjuster and remove with the spring.
9.
Replace with Lincat part number SP65 and reassemble.
10.
Reset burner pressure as per “Installation instructions”, “Pressure setting”.
Safety Thermostat.
1.
Drain oil from fryer tank.
2.
Remove the thermostat housing and locate the thermostat.
3.
Remove the brass nut holding the thermostat to the housing.
4.
Disconnect the wires from the thermostat.
5.
Undo the gland nut at the front of the tank.
6.
Unclip the thermostat phial from the bracket inside the tank.
7.
Pull the thermostat phial through tank. N.B. there will be some resistance due to the packing behind the
gland nut having become compacted.
8.
Reversal of above for re assembly.
Burner.
1.
Remove access panel at rear of appliance.
2.
Disconnect supply pipe from rear of burner at the inlet elbow.
3.
Unscrew the inlet elbow and remove. (The burner jet is located in the elbow).
4.
On Natural gas units remove the inlet baffle plate held by a single screw to the centre of the bracket.
5.
At the front of the appliance, locate the burner fixing screw under the chassis and remove.
6.
The burner can now be removed through the rear access opening.
7.
Reversal of above for re assembly.
