IS 358 ECN 3592
5
WARNING : Black domestic hoses are not suitable for this appliance.
When making the connection on to the appliance, secure the hexagon on the fitting to prevent rotation of the internal
pipework. An isolating cock should be fitted into the supply line to the unit for servicing purposes.
INSTALLATION INSTRUCTIONS (Continued).
Stabilising kit Installation instructions
In accordance with BS EN 203-1 : 1993 sections 4.7.1 to 4.7.1.2 in terms of Stability where either a J5
or J10 is to be used as a free standing unit it must be suitably fixed to the floor with the bracketry
provided.
Recommended Fixing Procedure.
1.
Site the fryer in its intended position, whilst complying with the instructions as detailed in the User
Document.
2.
Fit the upper brackets to the bottom of the unit using the screws provided.
3.
Loosely fit the lower brackets to the upper brackets.
4.
Mark the floor through the holes in the lower brackets.
5.
Move the fryer to one side and drill the floor at the marking out points. A 7mm drill is recommended to
accommodate the plugs provided.
6.
Fit the plugs to the drilled holes.
7.
Re-position the fryer so that the brackets align with the drilled holes.
8.
Screw the lower brackets in place using the self tapping screws provided.
9.
Level the fryer.
10.
Tighten the adjusting screws.
Parts list
2 x Upper brackets
2 x Lower brackets
8 x M5 x 20 Hex screws
4 x M5 Nuts
8 x M5 Flat washers
8 x M5 Shakeproof washers
4 x No12 x2” Slotted ro
und head screws
4 x Fixing plugs
