IS384 - ECN3345
Page 4
SECTION 2 - INSTALLATION
2.1 PREPARATION
1.
Remove all packaging materials and protective coatings from both the outer body and
the drip/crumb tray prior to installation.
2.
Remove transportation screws from rear panel of unit (see fig 2).
3.
Do not
use handle to carry unit.
2.2 SITING
1.
The appliance must be installed on a non-combustible, level surface in a suitable position
that is well lit, and positioned so as to prevent accidental touching.
2.
Partitions, walls, kitchen furniture and other materials less than 100 mm from the
appliance should be made from non-combustible material.
3.
Ensure there is a free flow of air and adequate ventilation around the appliance, and that
no vents are blocked.
4.
Silverlink Vertical Travel Salamanders can be either installed on a counter or wall
mounted using wall mounting brackets (see section 9 - optional accessories).
INSTALLING A WALL MOUNTED UNIT
1.
Refer to dimensional drawing (fig 1) and drawing of mounting holes (see fig 2).
2.
Use wall mounting kit supplied by Lincat (optional extra).
3.
Loosen 4 screws in back of unit.
4.
Fit brackets (x 2) to back of unit using existing screws.
5.
Drill 4 holes in wall according to drawing below.
6.
Secure unit to wall.
LOOSEN SCREWS (4 OFF)
IN BACK OF UNIT
FIT BRACKETS (2 OFF)
ONTO 4 SCREWS
TRANSPORTATION
SCREWS (2 OFF)
TO BE REMOVED
(Fig 2)
Mounting hole centres to
be used when unit is wall mounted.
