OPTITOME² HPC III
28
3 - Troubleshooting
Refer to the following:
•
Electrical diagram
•
Instructions of
HPC3 Digital Process HPi
(8695 4995) or,
•
Instructions of the different options.
4 - HMI alarm
List of most common alarms relating to the machine displayed on the HMI:
Fault
Probable causes
Possible remedies
29
: An axis limit has been reached
A position in the program has
overrun the software limits defined
for the machine.
Modify the program or the part
program zero point.
64
: Lag error axis (X, Y or W). Lag
exceeds the limit!
The axis position is different
from its control in an excessively
large value (due to an impact, for
instance)
Set the gantry straight (power off)
and set the zero point once again.
98
: Risk of collision: negative
radius or change in direction in
block no. xx
Kerf compensation is greater than
the radius of the part
Correct the program or the kerf
compensation.
199
: NC block incorrect. NC
address error (X or Y) Only a reset
is possible
A standard program has been
started without defining its zero
point.
Define the program zero point
(see instructions 8695 4995)
207
: Collision hazard, change in
direction at block no.
Kerf compensation is greater than
the space between cuts
Correct the program or the kerf
compensation.
288
: No tool has been selected
The program is a standard shape
and requires tool selection by the
HMI
Select the tool before starting the
program
960
: Axis (X or Y): Variable drive
alert - Axis at positive limit!
The + electrical limit switch has
been reached
Jog away the axis in the opposite
direction, and clear the alarm.
961
: Axis (X or Y): Variable drive
alert - Axis at negative limit!
The - electrical limit switch has
been reached
Jog away the axis in the opposite
direction, and clear the alarm.
1001
: The emergency stop is
active!
An emergency stop has been
engaged
Re-engage the emergency stop
buttons and put back into service.
1003
: The CNC has been stopped
by an emergency stop
The numerical control has
experienced a serious error during
operation
Check for additional errors and put
back into service
1004
,
1005
,
1006
: The variable
drive of axis xx is not ready
“DRIVEON”
The power supply of the variable
drive is missing
EtherCAT problem
Check the fuse F2 and enabling
of KM2 upon starting up. Check
the condition of the LEDs on
the variable drive. (on LM and T
variable drive: 2 flashing green
LEDs, on LE variable drive: 1
flashing green LED).)
1011
: Cycle stop for head
collision. Jog in limited speed
Torch impact (plasma) or probe
impact (oxy cutting)
Jog away the tool, restart the
program
Reminder: all work is to be carried out by approved and trained personnel.
Summary of Contents for 8695 4791
Page 6: ...OPTITOME HPC III VI ...
Page 11: ...5 User s guide ...
