English 15 English
Error Message - lack coolant flow
If coolant flow is not detected by system during welding,
an image will be shown on the screen as on Figure 39 or
40, machine will protect itself by automatically stop
welding output.
0092
Description
Cooler Shutdown
Press left button to exit
Figure 39
Figure 40
Press the left button / knob to delete error message. If
COOL ARC
®
26
is in
ON
mode machine reset is
required to continue welding. This behavior is to protect
the pump from damage and the torch from overheating.
WARNING
If during next welding attempts machine still display error
0092 Figure 39 please contact with the Technical Service
Center or Lincoln Electric.
Transport
To avoid freeze damage and water leakage during
transport, the coolant must be removed from the cooler
reservoir.
Maintenance
WARNING
For any repair operations, modifications or maintenance, it
is recommended to contact the nearest Technical Service
Center or Lincoln Electric. Repairs and modifications
performed by unauthorized service or personnel will
cause the manufacturer’s warranty to become null and
void.
Any noticeable damage should be reported immediately
and repaired.
ROUTINE MAINTENANCE
Check the condition of water-cooler hoses and
connections of the power lead.
Check the welding torch / gun condition: replace it, if
necessary.
Check condition and operation of the cooling fan. Keep
its airflow slots clean.
The reservoir volume should be checked daily before
using the cooler.
Keep the reservoir full, especially after disconnecting
the water lines or changing the accessory being cooled.
PERIODIC MAINTENANCE (NOT LESS THAN ONCE A
YEAR)
Perform the routine maintenance and, in addition:
Keep the machine clean. Using a dry (and low
pressure) airflow, remove the dust from the external
case and from the heat exchanger inside.
In dirty or dusty environments or if biological growth
occurs in the coolant, it may be necessary to flush the
coolant reservoir. Drain the old coolant, rinse the inside
of the reservoir and circulate rinsing solution through the
coolant system. Add new coolant when cleaning is
finished.
WARNING
Hot coolant can burn skin. Always be sure coolant is NOT
HOT before servicing the cooler.
