10
The following is a description of the user control function found on the WOC-2 operator pendant
enclosure:
•
RUN
- This switch is used to start and stop the oscillation cycle. It is also used
to initialize the mechanical slide assemble when the WOC-2 controller is power
up. Setting the switch to the “
ON
” position will start the oscillation cycle. Setting
the switch to the “
OFF
” position will terminate the oscillation cycle. When
stopping the oscillation cycle the slide will move back to the current oscillation
center position. When starting an oscillation cycle the slide will always move to
the CCW (Left) position first then return to the CW (Right) position.
•
JOG –
This switch is used position the slide to the desired center position. When
not oscillating and the switch is set to the “
CCW”
position slide will be move in
the CCW (Left) direction. When the switch is set to the “
CW
” position the slide
will be moved in the CW (Right) direction. If for some reason the slide has been
stalled or is no longer in the correct position the user can hold the switch in the
CW direction until the CW limit has been set. This will reset the WOC-2 control to
the max position of the slide.
•
SPEED –
The speed pot is used to control the speed of the slide. The actual
speed range will be determined by the mechanical slide assembly used with the
WOC-2 controller.
•
WIDTH –
The control will set the width of the oscillation pattern. The actual width
range will be determined by the mechanical slide assembly used with the WOC-2
controller.
•
LEFT DWELL –
This control sets the Left (CCW) oscillation position delay time.
The time range is adjustable from 0.05 to 2.00 seconds.
•
RIGHT DWELL –
This control sets the Right (CW) oscillation position delay time.
The time range is adjustable from 0.05 to 2.00 seconds.
Summary of Contents for CWT WOC-2
