English
English
9
3. With a 3/4” wrench, remove the bolt holding the
electrode lead to the gun adapter.
A. Bolt
B. Electrode
Lead
Figure #12
4. Use a 1/8” hex key to loosen the set screw securing
the gun adapter.
A. Set
Screw
B. Gun
Adapter
Figure #13
5. Remove the sense lead with a Phillips screw driver.
A. Sense
Lead
Figure #14
6. If a gas hose is attached to the gun adapter, use
pliers to remove the hose clamp and remove the
gas hose.
7. If the gun adapter requires guide tubes, install the
correct size guide tube and secure with the set
screw.
A. Set
Screw
B. Guide
Tube
Figure #15
Wire size
Number of grooves in
guide tube
0.6 – 1.2mm
1
1.2 – 1.6 mm
2
1.6 – 2.0 mm
3
2.0 – 2.8 mm
4
8. Assemble the sense lead to the new gun adapter.
Orient the lead towards the rear of the gun adapter.
9. If required, assemble the gas hose to the gun
adapter or the fitting on the feed plate and secure
with a hose clamp.
10. Assemble the gun adapter to the wire drive. Tighten
the set screw once the gun adapter is at a 90°
angle.
11. Bolt the electrode lead to the gun adapter, making
sure to route the lead straight down.
A. Bolt
B. Electrode
Lead
C. Keep Terminal and Lead Vertical
Figure#16
12. Assemble the gun adapter cover and secure with
the screw, lock washer and washer.
A. Screw
B. Gun Adapter Cover
Figure #17