B-1
OPERATION
OPERATION
s
n
o
i
t
u
a
c
e
r
P
y
t
e
f
a
S
Only use the product for the welding
processes described in the General
Description. Avoid using the product for
extracting and/or filtering fumes and gases which are
released during the following (welding) processes:
Never use the product for:
•
oxy-fuel cutting
•
aluminum laser cutting
•
oil mist
•
paint mist
•
extraction of hot gases (more than 80°C/176°F
continuously)
•
grinding aluminium and magnesium
•
flame spraying
•
extraction of cement, saw dust, wood dust, grit etc.
•
explosive environments or explosive substances/gases
(This list is not comprehensive.)
If the product is used in above situations it could result in
potential fire hazard, non-compliance with local
regulations and reduction in product performance and
life.
USERS
The use of this product is exclusively reserved to authorized, well-
trained and qualified users. Temporary personnel and personnel in
training can only use the product under supervision and respon-
sibility of skilled engineers.
Worker exposure level should be checked upon
installation and periodically thereafter to be certain it is
within applicable federal, state and/or local regulations
and guidelines (i.e. OSHA PEL and ACGIH TLV limits in
the U.S.).
INTENDED USE
The product has been designed as a filtration unit for dry dust and
fumes. Using the product for other purposes is considered
contrary to its intended use. The manufacturer accepts no liability
for any damages or injury resulting from such use. The product
has been built in accordance with state-of-the-art standards and
recognized safety regulations.
Only use this product when in technical perfect condition in
accordance with its intended use and the instructions explained in
the user manual.
MODIFICATIONS
Modifications of (parts of) the product is not allowed.
RESTRICTIONS
The Lincoln Electric ”BANK” system may only be used for filtration
of fumes and dust generated by some dry processing industries.
Max 80°C (176°F) gas temperature.
•
During use, always use Personal Protective Equipment
(PPE) to avoid injury. This also applies for persons who
enter the work area.
•
Check the working environment. Do not allow
unauthorized persons to enter the working
environment.
•
Protect the product against water and humidity.
•
Make sure the room is always sufficiently ventilated;
this applies especially to confined spaces.
Saturation or clogging of the filter cartridge results in a
decrease of the extraction capacity which could result in
a higher localized concentration of welding fumes.
The Lincoln Smart Connect™ controls will automatically maintain
airflow via a PID loop controlling in the Variable Frequency Drive
(VFD) located in the VFD enclosure assembly. The duct sensor is
wired into the VFD and controls motor speed so that it keeps the
duct pressure consistent. The PID setting to maintain the required
pressure and therefore airflow is set during installation of the unit.
For changes to this setting contact Lincoln Electric Service.
WARNING
WARNING
WARNING
WARNING
PRISM
®
Summary of Contents for Prism 4
Page 31: ...A 23 INSTALLATION d Reclasp filter handles FIGURE A 15 PRISM ...
Page 77: ......
