DTF – 1960 Series Operator Manual
11
WEEKLY CLEANING INSTRUCTIONS
1. Remove conveyor by pushing in the conveyor coupling. While holding the coupling in, lift up on conveyor
and slide out of unit. Place conveyor in large sink for cleaning. Spray entire conveyor with commercial
oven cleaner. Let sit for 15-20 minutes, use 3M green scrub pad to remove debris. Rinse and let dry.
2. By releasing the ¼-turn fasteners (Figure A), remove the four Air Wash Assemblies (Figure B). Please
note that the upper and lower air wash assemblies are interchangeable and, therefore, can be removed
and reinstalled in any of the four locations. Clean each air wash assembly with commercial oven cleaner
and rinse. Allow time to dry before reinstallation.
¼-Turn Fasteners
FIGURE A
FIGURE B
