DTF – 1960 Series Operator Manual
6
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL CODE REFERENCE
IN USA
When installed, this appliance must be electrically grounded and its installation must comply with the National
Electric Code, ANSI-NFPA 70, latest edition, the Manufacturer’s Installation Instructions, and applicable municipal
building codes.
IN CANADA
All electrical connections are to be made in accordance with CSA C22.1 – Canadian Electrical Code Part 1 and/or
local codes.
ALL OTHER COUTRIES
Local electrical codes will prevail.
1. Strain Relief is provided with each unit. International Dealer/Distributor provides applicable power cord/plug for
each customer.
2. All pole disconnection switch 3mm open contact distance.
3. To prevent electrical shock, an equal potential bonding ground-lug is provided in the back. This allows the
appliance to be connected to an external bonding system.
4. When used as a double-stack (if applicable) and each appliance has its own disconnection switch, all switches
should be closed together.
SPACING
The unit must have 6 inches (152mm) of clearance from combustible surfaces. In case other equipment is located
on the right side of the unit, a minimum clearance of 24 inches (610mm) is required from that equipment.
Additionally, a 24 inch (610mm) clearance at the rear of the unit must be obtainable for service access.
VENTILATION
Ventilation is not required but local codes prevail. These are the “authority having jurisdiction” as stated by the
NATIONAL FIRE PROTECTION ASSOCIATION, INC. in NFPA 96, latest edition.
WARNING:
!
If the supply cord appears to be damaged, do not attempt to operate unit. Contact
service agent or qualified technician to repair.
!
This appliance must be properly grounded at time of installation. Failure to ensure
that this equipment is properly grounded can result in electrocution, dismemberment
or fatal injury.
WARNING
INT’L (CE):
!
As it pertains to domestic models, this appliance is equipped with a three-prong
(grounding) plug for your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug.
WARNING
DOMESTIC:
