A
B
C
D
E
F
Table 2
Dimensions
A
16.5 in (
419,1 mm
)
B
17 in (
431,8 mm
)
C
8 in (
203,mm
)
D
4 in (
101,6 mm
)
E
7 in (
177,8 mm
)
F
0.438 in (
11,125 mm
)
Fig. 1
Dimensions
Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
Adjustments
. . . . . . . . . . . . . . . . . . . . .
Service instructions
Parts list
. . . . . . . . . . . . . . . . . . . . . . . . .
Warranty
. . . . . . . . . . . . . . . . . . . . . . . .
Safety
Personal injury and/or equipment damage
may result if proper safety precautions are
not observed.
• Do not connect inlet or output hoses if reel
is not properly installed.
• Slowly release fluid/gas pressure from
system before servicing reel.
• Do not connect supply to reel with any
source that exceeds maximum operating
pressure of reel.
• Use caution at all times, pressurized hoses
are very dangerous and can cause per-
sonal injury or death.
• Be aware of machinery and personnel in
work area.
• Remove system pressure immediately if a
leak occurs in the hose or reel.
• Exercise extreme caution with high
tension spring assembly contained in the
reel.
• Pull hose from reel by grasping the hose,
not the control valve.
• Do not pull or jerk on hose if reel stops
unwinding or winding. Remove system
pressure immediately.
• Observe all common safety practices.
note
Read this manual carefully before installing,
operating or servicing this equipment.
Table 1
Specifications
Model 89015
Maximum operating pressure
5 000 PSI
(344 bar)
Maximum operating temperature
210 °F
(99 °C)
Inlet
3
/
8
in NPT internal
Outlet
3
/
8
in NPT internal
Reel capacity
50 ft. x
3
/
8
in SAE 100R2
Application
Grease
Wetted seal type
Aflas
Swivel type
Ball bearing
2
