Page Number - 9
Form 422014
TROUBLESHOOTING
Condition
Possible Cause
Corrective Action
Motor fails to run.
- Battery needs charging.
Recharge battery.
- Faulty wiring to motor.
Remove battery, disassemble handle and
check wiring for loose connection.
Pressure Relief Valve opens to
- Blocked Line.
&KHFNOLQHVEUD]LQJDQGJUHDVH¿WWLQJWR
discharge grease.
- Blocked Bearing
remove or clean obstructions.
- Blocked Grease Fitting.
PowerLuber fails to dispense grease.
- Grease tube assembly is out of grease.
Check that grease tube assembly has grease.
- Loss of prime.
Repeat priming operation.
- Ball check item 22 is not functioning.
Remove Items 22 and clean and
inspect ball seat area.
PowerLuber continues to lose prime.
- Air may be trapped in several locations
(PSW\JUHDVHWXEHDVVHPEO\UH¿OODQG
LQFRQWDLQHUDIWHUEXON¿OOLQJ
repeat priming instructions.
- Follower may be binding in grease
Replace grease tube assembly Item 9.
tube assembly.
Battery fails to take a charge.
- Charger may not have power.
Check that receptacle has power.
- Battery may be bad.
Replace battery.
www.treboux.ch
info@treboux.ch
+41 (0)33 221 98 44