background image

Description

Lubrication controller 85307 is a universal 
electronic control unit compatible with  
dual-line, single-line and progressive  
lubrication systems. Provides flexibility and 
control over traditional single-line systems.

Controller digital display quickly identifies 

system status with easy-to-identify codes. 
Programming of unit requires simple  
information allowing operator to focus  
on specific utilized system.

Features

•  Runs progressive, single-line and  

dual-line lubrication systems.

•  Timing intervals from 5 seconds to  

24 hours.

•  Cycle counting.
•  10 V 

 to 30 V 

 operation.

•  Short circuit/open circuit detection with 

audible warning.

•  External fault lamp drive (flash or steady 

output). 

•  Low level reservoir monitoring.
•  Two sensor switch inputs.
•  Visual and audible fault indication.
•  Non-volatile memory.
•  Built-in blown fuse indicator.
•  3-digit LED display indicates exact  

system status.

•  Simple setup procedure.
•  Test mode allows testing of all circuits 

connected to controller.

•  Practical housing with mounting bracket.

Table 1

Specifications

Voltage

10 V 

 to 30 V 

Current drain

150 mA maximum (no load), 70 mA nominal

Pump output

7 A rms. maximum

Lamp output

3 A maximum

Switching

Solid state short circuit protected

Fuse

8 A fast blow 0.79 in 

(20 mm)

 glass

Connection

14 way MOLEX MINIFIT - JR

Communications

RS232 type

Dimensions

2.8 × 5.7 × 1.5 in 

(70 × 145 × 38 mm)

 

1)

Weight

0.66 lbs 

(300 g)

Protection

IP54

Temperature range

5 °F to 122 °F 

(–15 °C to +50 °C)

1)

  Includes mounting bracket.

Contents

Description

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 3

Features

 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 3

Specifications  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  3

Safety

 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 4

Operational precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  4
Explanation of signal words for safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  4

Keypad layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  5

LED code descriptions

 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 6

Setup mode 
Progressive-line system with no monitoring

 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 10

Running system (pump run) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  14
Running system (pump pause) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  14

Wiring diagram of progressive-line system without sensors  . . . . . . . . . . . . . . . . . . . . .  15
Wiring of pump with solenoid relay switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  15

Setup mode 
Progressive-line system with reservoir monitoring, run and pause time only

 . . . . . .

 16

Run mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  21
Running system (pump run) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  21
Running system (pump pause) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  21

Setup mode 
Progressive-line system with reservoir monitoring using run cycle counter

 . . . . . . .

 22

Run mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  27
Running system (pump run) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  27
Running system (pump pause) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  27

Wiring of pump with progressive-line system with sensors . . . . . . . . . . . . . . . . . . . . . .  28
Fault indications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  29

Warranty

 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

 32

2

3

Summary of Contents for SKF 85307


















Reviews: