FOOT REST
3. With the metal Seat Support Bar in an upright position slot the Foot Rest (D) into place and secure from
the rear with the Short Allen Bolts (L) and tighten using the Allen Key (M).
BACK REST SUPPORTS
4. Slot the Back Rest Supports (E) into place from above, paying close attention to the ‘L’ and ‘R’ markings
on the reverse. Use the palm of your hand to tap them into position so that the holes align with those on
the Base Assembly (A). Secure by pushing the Plastic Bolts (H) through the lower holes and secure at the
rear using 2 Plastic Nuts (O). Tighten using the Plastic Nut Spanner (N).
NOTE: There are small bobbles on the back of the Plastic Nuts (O) that sit in small holes on the Base
Assembly (A). The Plastic Bolts ere designed to be a snug fit so may need tapping into place with the palm
of your hand.
5
Summary of Contents for 44465
Page 3: ...3 F G J K L M N O H I...
