Linddana A/S
. Ølholm Bygade 70 . DK-7160 Tørring . T +45 75 80 52 00 . tp@linddana.com . www.linddana.com
Brugsanvisning: TP 230 fra dato 02.11.2015 ©Copyright 2008
15
8.3
Replacing wearing parts
8.3.1
Anvil
The anvil in the machine is used as a bedplate for the knives to cut the wood. The anvil must have
sharp edges, as otherwise the wood will bend and the cut edge will be frayed. The machine is
equipped with one horizontal anvil with two reversible cutting edges and one vertical anvil with
four reversible cutting edges.
What to do:
Stop the machine and turn off any power. Remove the screen above the revolving roller. Loosen
the bolts holding the two sections of the rotor housing together and open the rotor housing.
Using multigrip pliers lift the two springs off the revolving feed roller and pull the roller to the side
(See Figure 11)
.
Remove the three bolts holding the horizontal anvil in place. You access these from outside and
below. Take the anvil out from above and turn/replace. Before replacing the anvil, both the anvil
and contact surface must be carefully cleaned. The gap between the knife edge and anvil must be
1 mm
. (See Figure 12).
Figure 12 Gap between anvil and knife
