ˇ
soda coolers LINDR
17
How to work with the fittings:
4.
Push the tube into the fitting firmly (about 1.5 cm). The tube
must be cut straight to avoid any imperfect connections. If
you can´t insert the tube in, you need to moisten the end.
Disconnection of the fittings:
5.
Hold the gray ring towards the body of the fitting and pull
out the tube.
CAUTION:
If you don´t hold the grey ring while pulling the tube, the fit-
ting will cut even more into the tube.
THE TUBE MUST NOT BE UNDER PRESSURE WHEN DISCONNECTING !
First start:
6.
Check the connection of water and CO2 (as shown in picture, page 18-20).
7.
With SODA AS-45 GREEN LINE AND SODA AS-110 GREEN LINE, fill the cooling tank with
clean water.
8.
Connect the machine to the electrical network.
Turn on the machine:
9.
a) by switch (models SODA AS-45 GREEN LINE, SODA AS-110 GREEN LINE, EXTERNAL
CARBONATED WATER UNIT, SODA PYGMY 25 GREEN LINE)
b) by thermostat (model SODA PYGMY GREEN LINE)
10. Set the thermostat to the required temperature.
gray ring
