11.
Environmental Protection.
Sorting waste.
This product must not be disposed with a
household waste.
If you won´t use the Soda water cooler anymore, do not
dispose this product with a household waste. Make this
product available for separate collection.
Separate collection allows the recycling and
reuse of used products and packaging
materials. Local regulations may provide for
separate collection of domestic home
appliances in local centers or at point of purchase.
Reduce the pressure on the water valve to
2.0 bar. -Max 3.0 bar.
Open the valve on the water tap.
Open and check the inlet pressure CO2 on the cylinder
and adjust the pressure of CO2 to 4.0 to 4.5 bar.
Restart the machine by switching off the switch and
then switching it back on or unplugging the power
cord 230V. Again reconnect!
Check or replace the water filter.
The soda water does
not flow..
Pressure at the inlet has
exceeded 3.0 bar.
No water supply to
the water tap.
Inlet of pressure of Co2
is not open.
Water filter blocked.
The beverage is chilled
only a little.
Wrong setting of the
thermostat.
Bad air circulation.
The machine overheats.
Turn the thermostat knob clockwise to No. 7
Make sure the condenser plate are not clogged.
Place the machine to a cooler surroundings.
The tap twitches,
drink shoots out.
The high pressure on the
chilled beverage is too high.
Reduce the pressure.
The fittings do not
seal properly.
Poorly inserted tube.
Scratches on the hose.
Pull out the tube, check to see if there are not any sharp
edges, possibly shorten with knife.
Pull out and shorten for about 2cm.
Before calling for service:
Fault
Cause
How to f
ix it
Summary of Contents for SODA AS - 45
Page 6: ......