LINDR VK 15, Instruction Manual

MINI COMPRESSOR

9

NOTE:

 If the defect persists even after the above steps are taken, contact a service centre. 

15. TABLE OF MALFUNCTIONS

Malfunction

Cause

Removal

compressor does not run switch is in the off position

check the switch (2.)

regulation set to minimum

adjust pressure setting using the adjusting screw (3.)

power cable is not plugged 

in the socket properly

unplug the cable from the socket and replug it

issue with the socket

try connecting a different device to the socket

compressor runs but 

does not achieve the set 

pressure

leaky joints, air hose con-

nected incorrectly

unplug and replug the air hose in accordance with 

point 11. (How to Work with Speed Fittings)

Do not forget to specify the following: 

•  type of defect 

•  product type

•  production year

•  product's serial number (found on the machine plate) 

14. PUTTING INTO OPERATION

1. Interconnect the air supply and beverage supply. 

2. Connect the mini compressor to the power mains.

3. Check that all the joints and connections are sufficiently tight.

4. Turn on the air compressor using the switch and pressurise to the desired pressure. 

WARNING:

Use the device only as an accessory to flow-through coolers. Follow the safety 

instructions and do not overload the device. 

LINDR 15

 for pressurising a single beverage line with maximum flow rate of 

40 l/h

. 

LINDR 30

 for pressurising two beverage lines with maximum flow rate of 

120 l/h

.