LHA35RM 1 GHz MDU Distribution Amplifier
Installation Manual
INSTALLATION PRECAUTIONS TABLE
Precautions
Requirement
Facilitate service and maintenance
Allow a minimum of 35 in. (90 cm) clearance in front of the equipment rack(s)
Avoid direct heating or air conditioning
If unavoidable, use deflector plates
AC power source outlets
Locate equipment near sufficient outlets to provide power for test equipment and power tools
Rack support
Make certain rack supports are sufficiently rigid to support rack(s)
Building leakage
Beware of dripping water onto equipment from leaky roofs, waveguide roof entries, and cold water pipe condensations
2-2035 Fisher Dr, Peterborough, ON K9J 6X6 Canada
+1.705.742.1350
•
1.800.465.7046
•
support@lindsaybb.com
•
lindsaybb.com
© 2021 Lindsay Broadband Inc. All rights reserved. Printed in Canada. Non-Lindsay Broadband product marks,
service marks, and company names in this document are the property of their respective owners.
All information is subject to change without notice.
Rev. 06/21 (LBB0375)
•
Page 3 of 3
INSTALLATION & SETUP GUIDELINES CONT'D.
7.
Now install a plug-in equalizer into the forward mid-stage equalizer socket to get as close as possible to the desired output signal slope. The desired output slope is
determined by your system design. Consult your system planner or your system maps for this information.
8.
Make a final adjustment of the slope and output level with the input gain and slope controls. Always adjust the gain control, then the slope control in that order.
9.
Remember to replace cover after adjusting.
ORDERING INFORMATION
Part #
Description
LHA35RM
1 GHz, 2-way amplifier with 35 dB gain forward, 18 dB gain reverse, 42/54 diplexer, 110 V
Optional Accessories
GE-12-1GHz
1 GHz, 12 dB plug-in cable equalizer
GE-14-1GHz
1 GHz, 14 dB plug-in cable equalizer
