LTL HABMM
Issue 2.0
Page A1-6
Check condition of pulley (if installed in larger
balloons)
Combination Centering Pull-
Down Lines
Check general condition , no abrasion, heat
damage or excessive dirt
Check knot at parachute edge
Check attachment to quicklink at red (or red/white)
line pulley (secure, no abrasion)
BURNER
Outer Frame
General condition
Corner sockets and cable plates in good condition
Condition of corner welds
Centre Gimbal Frame
General condition
All bolts secure and in good condition
Check gimbal tension in both directions
Carabiners
Free of distortion
No corrosion or rust
Locking gates operate freely
Coil Assembly
Coils straight, all welds secure
Coil support brackets straight and secure (no
missing stainless rivets)
Check main jets for blockage and tightness
Slurper tubes secure and positioned over the low
point of the block.
Pilot Light
Pilot light cup secure (check set screw) and aligned
with piezo ignitor
Pilot jet free of obstruction (check fuel flow, sound
and flame appearance)
Pilot Light Regulator
Regulator valve handle turns freely
Piezo Ignitor
Piezo ignitor electrode in good condition
Piezo ignitor actuator button in good condition
Summary of Contents for Racer 56
