User Manual
English
Overview
Transmitter
– Front & Back Panels
1.
POWER:
Illuminates when the unit is powered
2.
DC 24V:
Plug the supplied 24V DC power supply into the unit
3.
HDBaseT OUT:
Connect to the HDBaseT IN port on the Receiver unit with a single Cat.6/7 cable for
transmission of all data signals – never connect to a network port
4.
HDMI IN:
Connect to an HDMI source device using an HDMI cable
5.
IR IN:
Connect the supplied IR Extender cable for IR signal reception. Ensure that remote being
used is within the direct line-of-sight of the IR Extender
6.
IR OUT:
Connect the supplied IR Blaster Cable for IR signal transmission. Place the IR Blaster in
direct line-of-sight of the equipment to be controlled
7.
RS-232:
Connect to a PC, Serial Controller or Serial device via phoenix block 3 way connection for
the transmission of RS-232 commands
8.
SERVICE:
Reserved for future use
9.
ETHERNET:
Connect to an internet or network connection – never connect to an HDBaseT port