User Manual
English
Display Control
The On and OFF buttons of the unit can be used turn the display on or off, however can also be
customized by sending RS232 commands or applying the IR learning function.
IR Learning
Press the IR Learning button to activate IR Learning mode, the On and Off LEDs will illuminate.
Using the unit’s display On/OFF button, press any button and the LED will begin to flash.
Point the displays IR remote at the unit’s IR receiver and press the Power On button of the remote. The
On LED on the unit will go dark.
Repeat the above steps to set the Off IR function
The unit’s On or Off buttons will now turn the display on or off.
Sending RS232 Commands
Connect a PC to the RS232 port
Install the RS232 control software on to the PC. The suggested software for use is CommWatch.exe
Once installed and all connections are made, double-click the software icon to run.
The control
software’s interface is shown below
Please set the parameters of the Command number, Baud rate, data bit, stop and the parity bit correctly.
Commands can now be sent in the Command Sending Area
Summary of Contents for 38282
Page 2: ......