User Manual
English
2. Fit the desk clamp (C) to the inside of the edge
bracket (B) using 2 x M6x10mm (D) bolts,
tighten it with the 4mm Hex Key (J).
For surfaces with a thickness of between 10
–
55mm, fix the clamp to the edge bracket in the
two highest holes.
For surfaces with a thickness of between 50-
85mm, use the two lowest holes.
3. Slide the base of the bracket over the edge of the
desk and turn the clamp clockwise to secure the
bracket. Although a foam pad is fitted to both
contact points, overtightening this clamp can
cause damage to the desk. While securing, check
for any play by trying to move the bracket to the
left and right. If there is any play, further tighten
the clamp until it requires reasonable force to
loosen.
.
The bracket is now installed.
