User Manual
English
If you would like to fit the bracket to a grommet, or hole in the desk, use the following steps:
1. Place the M8x100mm bolt (H) through the square gap in the centre of the grommet bracket (F) and
secure the grommet bracket (F) to the base of the gas-spring arm (A) with 3 x M6x12mm bolts (E)
with the 4mm Hex Key (J) (as shown below).
2. Place the base of the bracket over
the grommet and offer up the lower
grommet bracket (I) to the bolt on the
underside of the desk. Using the M8
wingnut (G), secure the base of the
bracket to the desk by turning
clockwise.
The bracket is now installed.
