CPU Switch Smart DVI
Installation and Use
Page 15
H7
- Hotkey combination is RIGHT CTRL + RIGHT ALT + command key
H8
- No hotkey combination enabled
F1
- Display firmware first digit
(Note: F1 is
F
F
followed by
1
1
NOT
l
l
)
F2
- Display firmware second digit
F3
- Display firmware third digit
F5
- Restore PS/2 mouse function
F6
- Restore IntelliMouse function
F8
- RESET all configurations to default settings. (Display confirms with 'r').
P
- Sets password - see section 4.6 for instructions.
E
- Exits configure mode and returns the CPU Switch Smart DVI to normal operation
mode.
2.8 Resetting the CPU Switch Smart DVI without disconnecting your
devices
The CPU Switch Smart DVI draws its power from the connected computers and
therefore may only be fully powered down when all the connected computers have
been switched off or disconnected. However, the CPU Switch Smart DVI may be
reset without disconnecting or powering down your computers by using the reset
switch on the underside of the unit. Performing a reset using this switch performs a
complete hardware reset on the CPU Switch Smart DVI and is equivalent to
switching off the power. To perform a hardware reset, move option switch 8 to the
ON position (halt and reset) and then back to the OFF position (normal operation).
2.9 Other useful installation information
PC boot up sequence
- When your PCs are powered on they communicate with
any attached keyboards and mice and setup parameters required by the particular
operating system. It is necessary for the CPU Switch Smart DVI to be attached and
powered on during this sequence so that it can give the required responses and
keep track of all the modes and settings requested by each of the connected PCs.
Mouse characteristics
- do not unplug a PS/2 mouse connection from a PC whilst
the PC is on. Due to the design of PS/2 mice communications the mouse function on
the PC will be lost and you will have to re-boot the PC to regain normal operation.
