7
DO1052DV
www.domo-elektro.be
NL
4.
Verwijder de onderste schroef, scharnierbeugel en het stelvoetje onderaan het apparaat.
Reverse Door
Tool required:
Philips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
Ensure the unit is unplugged and empty.
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on something solid
so that it will not slip during the door reversing process.
All parts removed must be saved to do the reinstallation of the door.
Do not lay the unit flat as this may damage the coolant system.
It
'
s
better
that
2
people
handle
the
unit
during
assembly
.
1. Remove two screws at rear side of top cover.
2. Remove top cover and thermostat knob, then place it aside.
3. Unscrew top hinge and then remove door and place it on a soft pad to
avoid scratch.
4. Unscrew bottom hinge. Then remove the adjustable feet from both
side.
7
unscrew
5.
Maak de scharnierpin los van de scharnierbeugel. Keer de beugel om en maak de pin weer vast.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable
feet.
7. Place the door back on. Ensure the door is aligned horizontally and
vertically, so that the seals are closed on all sides before finally
tightening the top hinge.
8. Put the top cover and fix it with 2 screws on the back.
Unscrew
Screw
8
Reverse Door
9. Fix the thermostat knob.
screw
6.
Bevestig de schroeven, scharnierbeugel en het stelvoetje aan de andere kant van de bodem.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable
feet.
7. Place the door back on. Ensure the door is aligned horizontally and
vertically, so that the seals are closed on all sides before finally
tightening the top hinge.
8. Put the top cover and fix it with 2 screws on the back.
Unscrew
Screw
8
Reverse Door
9. Fix the thermostat knob.
screw
7.
Zet de deur voorzichtig op zijn plaats. Zorg dat de deur zowel horizontaal als verticaal is uitgelijnd
zodat de afdichtingen op alle zijden gesloten zijn voordat je het bovenste scharnier volledig
vastmaakt. Breng de scharnier terug en schroef vast op de bovenkant van het apparaat.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable
feet.
7. Place the door back on. Ensure the door is aligned horizontally and
vertically, so that the seals are closed on all sides before finally
tightening the top hinge.
8. Put the top cover and fix it with 2 screws on the back.
Unscrew
Screw
8
Reverse Door
9. Fix the thermostat knob.
screw
Summary of Contents for Domo DO1052DV
Page 77: ...77 DO1052DV www domo elektro be SK ...
Page 78: ...78 DO1052DV ...