33
DO227SV
www.domo-elektro.be
EN
5.
The rotating floor brush may be rinsed off under running water. Make sure that it is completely dry
before using it.
6.
Place the floor brush back into the floor nozzle when it is clean.
7.
Replace the cover on the floor nozzle and tighten it back into place. Pay attention to the lock
symbol.
8.
Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the brushes.
PROBLEM AND SOLUTION
Problem
Solution
The machine does not start up.
· The battery is empty. Charge the machine.
· The battery is not inserted properly. Insert the battery until
it clicks into place.
The machine does not vacuum.
· The filters are dirty/the dust reservoir is full.
· The floor nozzle is clogged/the floor brush is blocked.
· The nozzle opening is clogged.
· Stuck hairs. Remove the hairs stuck on the brushes.
· Clean the machine as described in this manual.
The running time of the machine is
shorter and shorter.
· The machine is not sufficiently charged. Charge the
machine fully and try again.
· The battery is broken or old. Replace the battery.
The indicator light does not burn
while charging.
· There is poor contact.
· Check that the adapter is connected properly.
· Remove the dust on the connector of the upright vacuum
cleaner.
SPECIFICATIONS
Published information
Value and precision
Unit
Linea 2000 BV – Dompel 9 – 2200
Herentals – Belgium
-
-
Model number
DO227SV
-
Supply voltage
100-240
V
Power frequency
50-60
Hz
Output voltage
25.0 – 29.0
V
Output current
0.8
A
Output power
20.0 – 23.2
W
Average active efficiency
88.4
%
Efficiency at low load
83.0
%
Non-loaded energy consumption
0.08
W
