28
DO235SW
EN
Note: Make sure the parts are correctly assembled. If they are not properly assembled in the appliance,
the appliance will make a strange noise. If this happens, switch off the appliance immediately and
reassemble the parts.
1
2
3
4
Self-cleaning function for easy cleaning
The appliance is equipped with a self-cleaning function for easy cleaning. For a thorough cleaning, we
recommend following the previous steps. To quickly clean the appliance, follow the steps below.
1.
Remove the water reservoir and turn it upside down. Open the screw cap and fill the water reservoir
with water and detergent up to the maximum cleaning level, which is 260 ml. Put the screw cap back
on the reservoir and place it back in the appliance.
2.
Pour some water into the storage base and place the appliance in its base.
3.
Connect the charger to the appliance.
4.
Hold down the water spray button for a few seconds. The green indicator light flashes. The rollers
will start to turn.
5.
The appliance will now start its self-cleaning programme. This cycle lasts 2 minutes. To end the
cleaning earlier, press the water spray button or the on/off button at any time.
6.
If the rollers are still slightly dirty after 2 minutes, or there is still some foam on the rollers, turn this
function on again. If the rollers are not completely clean afterwards, clean them thoroughly.
Note: The self-cleaning function is mainly to clean the 1st roller. If you also want to clean the 2nd roller,
swap them over. If they are not clean after 2 cycles, remove them from the cleaning head for a thorough
cleaning.
最大
350mL
自清洗
260mL
260mL
最大
350m
L
自清
洗
260m
L
260
mL
CLEANING THE DIRTY WATER RESERVOIR
1.
Remove the cleaning head cover using the release buttons. Clean this with a damp cloth and then
dry.
2.
Take out the dirty water reservoir by pulling it up with the handle.
3.
Empty the reservoir by opening the lids of the 2 compartments. Pour the contents into the sink.
Clean the accessories in warm water with a mild detergent. Dry thoroughly.
4.
Clean the holder for this reservoir with the cleaning brush or a damp cloth. Dry afterwards.
5.
Put the dirty water reservoir back into the appliance and put the cover back on the cleaning head.
