DO7051S
48
PARTS
1. Bottom plate
2. Spray opening
3. Water reservoir
4. Spray button
5. Steam boost button
6. Steam regulation button
7. Cord
8. Indication light
9. Temperature button
10. Self-cleaning button
BEFORE FIRST USE
• The iron must always be at “Min” if you put the plug in or take it out of the
outlet.
• Wait until the iron has cooled completely before putting it away.
• Never pull on the cord but on the plug itself.
• Do not use other devices with a high power usage on the same electrical group to
prevent possible overloading.
• Remove the plastic protection from the sole of the iron (if present) and clean the
sole of the iron with a soft cloth.
• Some parts of the iron have been greased lightly, so the device may emit a slight
odour and some smoke with initial use. This is normal and will not happen after
initial use.
• Keep the sole of the iron smooth and be careful for scratches. Do not slide with
the sole of the iron over metal surfaces, such as the edge of the ironing board,
buttons or zippers.
• Fill the water reservoir as indicated in “Filling the water reservoir”.
• Make sure that the steam regulation button is at “0”.
• Put the plug of the device in the outlet, the indicator light will light up.
• Turn the temperature button to the MAX position. The indicator light will show
that the device is heating up.
• The indicator light will turn off when the device has reached the temperature.
• Slide the steam regulator button to the desired position, from “0” to “4”. Steam
will come out of the sole of the iron.
• With initial use, iron an old towel.
• When the water reservoir is empty, no more steam will be produced, and the
preparations are completed.
